**From:** Maxim Belkin (*mbelkin_at_ks.uiuc.edu*)

**Date:** Fri Apr 01 2016 - 12:21:05 CDT

**Next message:**faride badalkhani: "Re: maximum coordinate is negative for z"**Previous message:**Aron Broom: "Re: maximum coordinate is negative for z"**In reply to:**Aron Broom: "Re: maximum coordinate is negative for z"**Next in thread:**faride badalkhani: "Re: maximum coordinate is negative for z"**Reply:**faride badalkhani: "Re: maximum coordinate is negative for z"**Messages sorted by:**[ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Aron is correct (except that it is cellbasisvector, not callbasisvector)

Also, use "pmePencils 1", rather than the trio pmeGridSizeX, pmeGridSizeY, pmeGridSizeZ

*> On Apr 1, 2016, at 12:16, Aron Broom <broomsday_at_gmail.com> wrote:
*

*>
*

*> I believe the callBasisVector is based on the total length along that axis, so you still just want to calculate Zmax - Zmin, it doesn't matter if they are both negative.
*

*>
*

*> On Fri, Apr 1, 2016 at 1:14 PM, faride badalkhani <farideh.khamseh_at_gmail.com <mailto:farideh.khamseh_at_gmail.com>> wrote:
*

*>
*

*> dear all,
*

*>
*

*> I want to assign cellbasisvectors in the configuration file, but the maximum coordinate in z direction is -2.355. Therefore, How can I determine PMEGridSize z so that it
*

*> can be factorized by 2, 3, or 5?
*

*>
*

*> Any help will be appreciated.
*

*>
*

*> Regards,
*

*> Farideh
*

*>
*

*>
*

*>
*

*>
*

*> --
*

*> Aron Broom M.Sc
*

*> PhD Student
*

*> Department of Chemistry
*

*> University of Waterloo
*

**Next message:**faride badalkhani: "Re: maximum coordinate is negative for z"**Previous message:**Aron Broom: "Re: maximum coordinate is negative for z"**In reply to:**Aron Broom: "Re: maximum coordinate is negative for z"**Next in thread:**faride badalkhani: "Re: maximum coordinate is negative for z"**Reply:**faride badalkhani: "Re: maximum coordinate is negative for z"**Messages sorted by:**[ date ] [ thread ] [ subject ] [ author ] [ attachment ]

*
This archive was generated by hypermail 2.1.6
: Sun Dec 31 2017 - 23:20:17 CST
*