From: Faezeh Mottaghitalab (faezeh.mt258_at_gmail.com)
Date: Fri May 09 2014 - 13:10:55 CDT
sorry! i didn't pay attention.
right.i changed the topology file to "RET" instead of changing the PDB
file into "RTAL" and in the minimization step with 1000 steps minimization
i get the error :
" Warning: Low global exclusion count!
Warning: This warning is not unusual during minimization"
and at last it said : "simulation has become unstable"
i increase the steps of minimization to 1500 and until now it seems that
there is no problem.
but i think that i should do what you said. i'd better change the PDB file.
thank you very much
On Fri, May 9, 2014 at 9:08 PM, Kenno Vanommeslaeghe <
kvanomme_at_rx.umaryland.edu> wrote:
> Please reply to the list rather than personal e-mail (hint to the list
> admin: Majordomo has an option to override the Reply-To: address!)
>
> On 05/09/2014 10:06 AM, Faezeh Mottaghitalab wrote:
>
>> * i understand where was the problem. i must make some changes on the
>> topology file.*
>>
>
> Of all the possible workarounds, I would say this is the least ideal
> option; the modified topology invariably ends up in the hands of someone
> who runs into problems with it. The arguably better solutions are:
> - explicitly instruct CHARMM/psfgen/VMD that "RET" in the pdb corresponds
> to "RTAL" in the topology (if possible/applicable)
> - edit the PDB so that it says "RTAL" (assuming your software can read the
> CHARMM variant of the PDB format that allows for 4-character residue names)
>
>
This archive was generated by hypermail 2.1.6 : Wed Dec 31 2014 - 23:22:24 CST