From: Mert Gür (gurmert_at_gmail.com)
Date: Thu Sep 02 2010 - 15:03:21 CDT
This question is just out of curiosity.
One of my friends did a long MD simulation writing "rigidbonds off" in
the configuration file.
However in the user guide it says that
Acceptable Values: none, water, all
My friends MD simulation have run for a long time.
Does using "rigidbonds off" mean "rigidbonds none"?
If so could I use "off" for any of the "none" values in the configuration file?
If it does not mean "rigidbonds none" how can I check what it actually did?
I am asking these questions because I am planning to use the resulting
trajectory for further analysis (TMD and SMD).
This archive was generated by hypermail 2.1.6 : Wed Feb 29 2012 - 15:54:29 CST