From: Peter Freddolino (petefred_at_ks.uiuc.edu)
Date: Wed Jun 28 2006 - 14:09:13 CDT
In this case you don't need the xsc file; just leave your periodic cell
definitions exactly the same as they were in the original config file.
Ana Celia Araujo Vila Verde wrote:
> Dear NAMD users,
> I am restarting a simulation that was performed in the NVT ensemble.
> Do I need to use the xsc file in my restart simulation?
> I have thought about this and my guess is "no", because the simulation
> cell does not change its shape in an NVT simulation. However, I'd like
> to confirm this before I continue. I have read the manual and searched
> the archives in the NAMD list but I could not find any information
> about this.
> Thank you in advance for everyone's time and attention. Best regards,
> Ana CÚlia Ara˙jo Vila Verde
> Penn State University
> Department of Chemical Engineering
> Fenske Laboratory
> University Park, PA 16802
> Phone: +(1) (814) 863-2879
> Fax: +(1) (814) 865-7846
> avilaverde_at_engr.psu.edu <mailto:avilaverde_at_engr.psu.edu>
This archive was generated by hypermail 2.1.6 : Wed Feb 29 2012 - 15:42:16 CST